| General specifications |
|---|
| Effective detection range | Standard : 0.3 … 6 m |
| Threshold detection range | 7.5 m |
| Light source | IRED |
| Light type | modulated infrared light , 850 nm |
| Field height | see Table 1, max. 3000 mm |
| Beam crossover | Factory setting: three beam crossing, deactivateable |
| Beam blanking | adjustable max. 2 fixed suppressible beam areas (blanking) |
| Beam spacing | 50 mm |
| Number of beams | see Table 1, max. 61 |
| Operating mode | Emitter: Emitter power adjustable in two ranges |
| Optical resolution | without beam crossover: 50 mm
with beam crossover: 25 mm with in 25% and 75% of the range |
| Angle of divergence | 10 ° |
| Ambient light limit | > 50000 Lux (if external light source is outside the opening angle) |
| Functional safety related parameters |
|---|
| MTTFd | 56 a |
| Mission Time (TM) | 20 a |
| Diagnostic Coverage (DC) | 60 % |
| Indicators/operating means |
|---|
| Operation indicator | LED green:
constantly on – power-on
double pulse flashing (0.8 Hz) – undervoltage
flashing (4 Hz) – short circuit
flashing with short interruptions (1 Hz) – IO-Link mode |
| Status indicator | Emitter: LED yellow
constantly on – high emitter power
constantly off – low emitter power
flashing (8 Hz) – error message
Receiver: LED yellow:
constantly on – object detected
constantly off – no object detected
flashing (4 Hz) – below stability control limit
flashing (8 Hz) – error message |
| Control elements | Receiver: 2 touch buttons for programming |
| Electrical specifications |
|---|
| Operating voltage | 18 … 30 V DC |
| Ripple | 10 % |
| No-load supply current | Emitter ≤: 50 mA
Receiver: ≤ 150 mA (without outputs) |
| Time delay before availability | see Table 1, max. 1.5 s |
| Interface |
|---|
| Interface type | IO-Link ( pin 4 ) |
| IO-Link revision | 1.0 |
| Device ID | 1050371 … 1050398 ( 0x100703 … 0x10071E ) |
| COM-Mode | COM 2 (38.4 kBaud) |
| Min. cycle time | 2.3 ms |
| Process data width | 16 bit |
| SIO mode support | yes |
| Input |
|---|
| Test input | Emitter switch-off with +UB or 0 V at pin 4 (emitter) |
| Function input | Range input activation from 1.6 m with +UB or 0 V on pin 2 (emitter)
Teach-In input for parameterization on pin 8 (receiver) |
| Output |
|---|
| Pre-fault indication output | Stability Control (SC) 1 PNP, short-circuit protected, reverse polarity protected on pin 2 (receiver) |
| Switching type | Factory setting: dark on , Switchable to light-on mode |
| Signal output | Command interface: Pin 4 IO-Link interface C or used as switching output Q; 1 short-circuit proof reverse polarity protected push-pull output (receiver)
Switch output: Pin 5 switching output Q; 1 short-circuit proof reverse polarity protected push-pull output (receiver) synchronized with pin 4 |
| Switching threshold | Factory setting: The signal tracking for the threshold value is deactivated, increasing the optical resolution by a maximum of 4 mm; switchable to active signal tracking |
| Switching voltage | max. 30 V DC |
| Switching current | max. 100 mA |
| Voltage drop | ≤ 2 V DC |
| Switching frequency | see Table 1, max. 129 Hz |
| Response time | see Table 1, max. 8 ms |
| Timer function | Off-delay programmable from 0 … 1.25 s in 5 ms steps (adjustment via IO-Link only) |
| Conformity |
|---|
| Communication interface | IEC 61131-9 |
| Product standard | EN 60947-5-2 |
| Approvals and certificates |
|---|
| Protection class | III ( IEC 61140 ) |
| UL approval | cULus Listed |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Ambient conditions |
|---|
| Ambient temperature | -30 … 60 °C (-22 … 140 °F) |
| Storage temperature | -30 … 70 °C (-22 … 158 °F) |
| Mechanical specifications |
|---|
| Conductor cross section | min. 0.25 mm2 |
| Housing width | 20 mm |
| Housing depth | 30.5 mm |
| Housing length L | see Table 1, max. 3160 mm |
| Degree of protection | IP67 |
| Connection | Emitter: connecting cable with 4-pin, M12 x 1 connector , 330 mm total length
Receiver: connecting cable with 8-pin, M12 x 1 connector , 350 mm total length |
| Material | |
| Housing | extruded aluminum section , Silver anodized |
| Optical face | Plastic pane , Polycarbonate |
| Mass | see Table 1, max. 1650 g (per profile) |
| Cable length | max. 30 m |
