Description
The CT series force transducers, have been specially desi- gned for use in polymer processing in applications where it is required to measure the reaction force produced by the extru- sion pressure on the gearbox along the axis of the screw.
They measure a force whose value is indicative of the extru- sion pressure over the area of the screw.
The CT series force transducers can also be used in all other applications where it is required to measure the forces on shafts or columns and in any application where the geometry demands a toroidal form load cell.
TECHNICAL DATA OF CT
| Accuracy | 0,5% |
| Nominal full scale load (Ln) | 100…3000 kN |
| Nominal output at FSO | 2mV/V |
| Output tolerance at Ln | <± 1% FSO |
| Combined errors: Non linearity Histeresis, Repeatibility | < ± 0,5% FSO |
| Creep (after 30 min. at Ln) | < ± 0,06% FSO |
| Zero load out of balance signal | < ± 1% FSO |
| Calibration signal * | 80%FSO ± 1% |
| Thermal drift in Sensitivity compensated Zero range Calibration | < ± 0,02% FSO°C < ± 0,02% FSO°C < ± 0,02% FSO°C |
| Nominal input resistance | 700 Ohm |
| Isolation resistance | > 10 GOhm |
| Nominal supply voltage | 10 V |
| Maximum supply voltage | 15 V |
| Compensated temperature range | -20…+50°C |
| Maximum temperature range | -20…+60°C |
| Storage temperature range | -30…+80°C |
| Permitted static load | 130% Ln |
| Maximum applicable load | 150% Ln |
| Rupture load | > 300% Ln |
| Maximum static lateral load | 40% Ln |
| Maximum elastic deformation at Ln | < 0,1 mm |
| Grade of protection (DIN40050) | IP65 |
| Electr. connections: Connector | VPT02A10-6PT2 |
| Elastic element material | Stainless steel |
| Case material | Anodize aluminium |
| * The exact value is indicated on the instrument nameplate. |
