Description
Pancake like diaphragm load cell designed for the use in Fully electric Injection Molding Machines.
The Flat-Body design allows for easy integration into the injection unit without adding to the machine length. Available with standardized mV/V output or an EEPROM- Module to allow for higher mV/V-Output for better signal/ noise ratio (to be used with special VDA-Amplfier).
High-grade steel for endless cycles and optional amplifer necessary.
TECHNICAL DATA OF DLC
| Strain gauge type | Foil (GF = 2.0 nominal) |
| Bridge resistance | 700Ω (@ 8 strain gauges) |
| Measuring range | 60…650 kN |
| Sensitivity | 1mV/V |
| Sensitivity tolerance | ± 1% |
| Accuracy | < ± 1% FS |
| Linearity | < ± 0.6% FS |
| Hysteresis | < ± 0.6% FS |
| Repeatability | < ± 0.2% FS |
| Supply voltage | 5VDC (max 8VDC) |
| Operating temperature range | -20…85°C |
| Storage temperatur range | -20…85°C |
| Temperature effect on zero balance @ 10°C | 0.15% |
| Temperature effect on output @ 10°C | 0.15% |
| Maximum applicable load | 150% |
| Rupture load | >200% |
| Protection class | IP54 |
| Case material | Steel |
